Page Comparison

...

4.) Once logged in open the Dashboard and Gateway UI by clicking on setting icon on the project and clicking on Launch App option as shown in image below.

 Image Added                    Image Removed                                                                      Image Removed Image Added 

5.) Go to the Gateway UI and click on the Simulator Icon, select some simulation Interval like 30 seconds, and click on Update and then click on close after that.

...

6.) The simulation should start running and you should see the sensor data on preconfigured sensor hub by clicking on the sensor hub on map.

                  Image Added                  Image Removed                                                 Image Removed  Image Added

7.) You should also start seeing the calibrated sensor value on Dashboard UI.

Image Added                                    Image Removed                                                 Image Removed  Image Added

8.) You can also run the queries in queries tab of the project, select the project go to queries tab and select the endpoint as current and then run the queries.queries   Image Added                                Image Removed                                                  Image RemovedImage Added

the details of various queries and their explanation can be found in the following link.

...